Step 1
| 
Step 2
| 
Step 3
|
In the case of FOLD-em template #1, you'll notice that there are 2 corners, however,
they are only 45 degree corners versus the 90 degree corners we had in FOLD-em template #2.
With this template, we recommend you start cutting
from either end of the overall slit (for right-handed cutters, start from the left side, for left-handers
start cutting from the right). See step 1. Cut to the first corner.
Without lifting the blade, rotate slightly to line it up with the next section on the slit (step 2).
Cut that section, rotate again to line up with the last section of the slit and finish your cut (step 3).
Remember to not run your blade over the template when you reach the end of a slit.
Cutting the flap in one cutting motion will assure you of a complete cut.
Fold the flaps in the same manner as explained in the previous page.
|